Flush Pull Handle Installation Guide:

1. Measure the desired height and centre position that the flush pull will sit at from a fixed point (door edge, door frame, etc.)

2. Mark the required cutout length (L) and width (W) from the flush pull back box. Use a spirit level to ensure the cutout shape is level.

3. Use a chisel or prefered method to evenly remove material to the correct depth (D) as shown in the table below. If installing flush pulls back-to-back, you may choose to cut a hole right through the door.

4. Ensure the alignment of the back box matches the shape and size of the cut out made. Adjust if needed.

5. Apply the necessary amount of adhesive as required by the surface condition to the cut surface of the door and press flush pull into cavity. Silicone based adhesive is recommended.

6. If required, use the included brad nails or fixing screw(s) to secure the top and bottom of the back box into the the cavity.

7. For flush pulls with one fixing point, put fixing point on top.

Download PDF